I tried to print out a dragon head war hammer and a couple maces I designed, but as I said in my last post, I didn't get the supports attached properly in the slicer so only the hammer head printed properly - not the handle and not the maces. I have to say, I'm pretty pleased with the resin. It has a nice finish and seems to take detail well. It's hard to see the detail on the unpainted pics, but after a light brushing of paint, they really pop. This was printed on a stock Anycubic Photon using the Eryone water washable resin, using Eryone's recommended cure settings.
Unpainted If I had a better camera, I could probably get some good pics, but I'm using my phone which just can't grab the detail of the unpainted model:
Painted (I didn't paint it, so much as gave it a thorough drybrush covering):
You can see the scales and eye of my design:
Headshot from slightly above. I'm really pleased with how it holds the detail:
Face-on:
EDIT: And the 'water washable' part is very accurate. I rinsed the head under water and it was clean in no time. I got some on my hand and unlike standard resin that's sticky and tough to get off even with IPA, it washed right off in soapy water. Cleaning the resin vat and build plate was also fast and easy.